Home Company Info Product List Contact Details
Homeproduct Directory

Modify Parts CDI tester

Modify Parts CDI tester
company Shenzhen Junesun Industry Co.,Ltd.
Categories Battery Testers
Update2010-12-30
Original RegionChina
Modify Parts CDI tester

This is a special product for testing the ignition box.

OPERATING INSTRUCTIONS
1. Make sure the red light on the front/left side of the tester is off. If it's on, push the ON/OFF button once
to turn it off.
2. Remove the high tension coil wire from the center of the distributor cap. Plug the test plug into the coil
wire. Connect the test plug to engine ground, such as a valve cover bolt.
NOTE: This step is important! If you do not install the test plug, your ignition system could be damaged!
3. Refer to the hookup diagrams in the following pages. Find the hookup diagram matcheing your ignition
system and connect the tester accordingly.
4. Set the RPM dial on the tester to 1000. Set the cylinder select knob to match your engine. Rotary
engines use the 4 cylinder setting.
5. Turn on the car’s ignition switch, then push the ON/OFF button on the tester once to turn it on. The
test plug should begin sparking. Use the RPM knob to vary the operating RPM of the system.
6. When done testing, push the ON/OFF button once to turn the tester off, then turn off the car's ignition
switch. Disconnect the tester and test spark plug, reconnect the coil high tension lead to the distributor
cap, and reconnect any car harnesses disconnected in Step 3. Test start the car.

<< Back

Modify Parts CDI tester on sale

Products Showcase

See more products from this supplier.

Do you want to show products of your own company? Join FREE now!

You may also be interested in: